Skip to content
CalContractorPrep
Menu

CSLB General Building (B) practice questions: Concrete

Section 3 of 5: Core Trades

4 free practice questions on concrete, part of a section that is about 30% of the General Building exam. Try each one, then open the answer: every choice is explained, and the answer names the code section or public rule it comes from.

Questions and answers

  1. 1. What minimum 28-day compressive strength does the California Residential Code require for an interior slab-on-grade (not a garage floor), in any weathering region?

    Core Trades

    • A. 2,500 psi
    • B. 3,000 psi
    • C. 3,500 psi
    • D. 4,000 psi
    Show answer

    Correct answer: A

    • A. 2,500 psi

      Correct answer

      Correct: 2,500 psi in every weathering region (Table R402.2).

    • B. 3,000 psi

      3,000 psi applies to some weather-exposed concrete, not interior slabs.

    • C. 3,500 psi

      3,500 psi applies to porches, steps and garage floors in severe weathering.

    • D. 4,000 psi

      Higher than any value in the residential table for this use.

    Explanation

    California Residential Code section R402.2 (Table R402.2) sets 2,500 psi as the minimum 28-day compressive strength for basement slabs and interior slabs on grade (except garage floors) in negligible, moderate and severe weathering regions alike.

  2. 2. A house with wood siding (no masonry veneer) sits on a concrete foundation wall. Under the California Residential Code, what is the minimum height the foundation wall must extend above the adjacent finished grade at all points?

    Core Trades

    • A. 4 inches
    • B. 6 inches
    • C. 8 inches
    • D. 12 inches
    Show answer

    Correct answer: B

    • A. 4 inches

      4 inches applies only where masonry veneer is used.

    • B. 6 inches

      Correct answer

      Correct: 6 inches (R404.1.6).

    • C. 8 inches

      More than required.

    • D. 12 inches

      More than required.

    Explanation

    California Residential Code section R404.1.6 requires concrete and masonry foundation walls to extend above the adjacent finished grade by at least 6 inches, or at least 4 inches where masonry veneer is used.

  3. 3. A new house slab requires a vapor retarder, so CALGreen also requires a capillary break. Using CALGreen's base-course method (not an engineered design), which installation is correct?

    Core Trades

    • A. A 2-inch sand layer placed on top of the vapor retarder
    • B. 4 inches of native soil compacted to 90 percent under the vapor retarder
    • C. A 4-inch base of 1/2-inch or larger clean aggregate, with the vapor retarder in direct contact with the concrete
    • D. A second layer of 6-mil polyethylene laid over the first
    Show answer

    Correct answer: C

    • A. A 2-inch sand layer placed on top of the vapor retarder

      Sand on top would separate the vapor retarder from the concrete; the method requires direct contact.

    • B. 4 inches of native soil compacted to 90 percent under the vapor retarder

      Compacted native soil is not the clean-aggregate base the method calls for.

    • C. A 4-inch base of 1/2-inch or larger clean aggregate, with the vapor retarder in direct contact with the concrete

      Correct answer

      Correct: CALGreen 4.505.2.1 base-course method.

    • D. A second layer of 6-mil polyethylene laid over the first

      A second sheet of plastic is not a capillary break.

    Explanation

    CALGreen section 4.505.2.1 lets the capillary break be a 4-inch-thick base of 1/2-inch or larger clean aggregate, with the vapor retarder in direct contact with the concrete and a concrete mix design that addresses bleeding, shrinkage and curling. Other options are an approved equivalent method or a slab design by a licensed design professional.

  4. 4. Concrete is going into removable forms for a house foundation wall, and no special segregation-resistant mix has been approved. What is the maximum slump allowed under the California Residential Code?

    Core Trades

    • A. 3 inches
    • B. 4 inches
    • C. 5 inches
    • D. 6 inches
    Show answer

    Correct answer: D

    • A. 3 inches

      Allowed, but not the maximum.

    • B. 4 inches

      Allowed, but not the maximum.

    • C. 5 inches

      Allowed, but not the maximum.

    • D. 6 inches

      Correct answer

      Correct: 6 inches maximum in removable forms (R404.1.3.3.4).

    Explanation

    California Residential Code section R404.1.3.3.4 limits the slump of concrete placed in removable forms for foundation walls to 6 inches, measured by ASTM C143. Higher slump in removable forms needs approval for a segregation-resistant mix.

Keep studying

Read the Section 3 study notes: Core Trades

All General Building topics

Study guides for this section

Test yourself

Try 25 free General Building practice questions from all five sections. Each answer explains the rule and names the code section it comes from. No sign-up.

See what the General Building exam covers