Skip to content
CalContractorPrep
Menu

CSLB General Building (B) practice questions: Roofing

Section 3 of 5: Core Trades

4 free practice questions on roofing, part of a section that is about 30% of the General Building exam. Try each one, then open the answer: every choice is explained, and the answer names the code section or public rule it comes from.

Questions and answers

  1. 1. A chimney 36 inches wide, measured perpendicular to the slope, comes through a sloped roof below the ridge. What is required on its ridge side?

    Core Trades

    • A. A cricket or saddle
    • B. A second layer of underlayment only
    • C. A 4-inch curb
    • D. Nothing more than step flashing
    Show answer

    Correct answer: A

    • A. A cricket or saddle

      Correct answer

      Correct: wider than 30 inches, so R903.2.2 requires a cricket or saddle.

    • B. A second layer of underlayment only

      Extra underlayment does not divert water around the chimney.

    • C. A 4-inch curb

      A 4-inch curb is the skylight curb rule for low-slope roofs, not a chimney rule.

    • D. Nothing more than step flashing

      Step flashing alone is not enough on a penetration over 30 inches wide.

    Explanation

    California Residential Code section R903.2.2 calls for a cricket or saddle on the upslope (ridge) side of a chimney or other penetration wider than 30 inches, with the width taken perpendicular to the slope. The cricket is covered with sheet metal or the same material as the roof.

  2. 2. What is the minimum roof slope for clay or concrete roof tile?

    Core Trades

    • A. 2:12
    • B. 2-1/2:12
    • C. 3:12
    • D. 4:12
    Show answer

    Correct answer: B

    • A. 2:12

      2:12 is the asphalt shingle minimum.

    • B. 2-1/2:12

      Correct answer

      Correct: R905.3.2 sets 2-1/2:12 for clay and concrete tile.

    • C. 3:12

      3:12 is the wood shingle and shake minimum.

    • D. 4:12

      4:12 is where single underlayment may be used under tile, not the minimum slope.

    Explanation

    California Residential Code section R905.3.2 requires a slope of 2-1/2:12 or greater for clay and concrete tile, with double underlayment from 2-1/2:12 to 4:12.

  3. 3. The manufacturer's instructions do not call for extra nails. What is the fewest fasteners allowed per asphalt strip shingle on a 6:12 roof?

    Core Trades

    • A. Two
    • B. Three
    • C. Four
    • D. Six
    Show answer

    Correct answer: C

    • A. Two

      Two is the minimum for an individual shingle, not a strip shingle.

    • B. Three

      Fewer than the four-fastener minimum.

    • C. Four

      Correct answer

      Correct: R905.2.6 sets a minimum of four per strip shingle.

    • D. Six

      More than the code minimum.

    Explanation

    California Residential Code section R905.2.6 requires the number of fasteners the manufacturer specifies, but never fewer than four per strip shingle or two per individual shingle.

  4. 4. Step flashing is installed where an asphalt shingle roof meets a sidewall. What are the minimum dimensions of this base flashing?

    Core Trades

    • A. 2 inches high by 4 inches wide
    • B. 3 inches high by 3 inches wide
    • C. 4 inches high by 2 inches wide
    • D. 4 inches high by 4 inches wide
    Show answer

    Correct answer: D

    • A. 2 inches high by 4 inches wide

      Too short; the minimum height is 4 inches.

    • B. 3 inches high by 3 inches wide

      Smaller than the 4-by-4-inch minimum.

    • C. 4 inches high by 2 inches wide

      Too narrow; the minimum width is 4 inches.

    • D. 4 inches high by 4 inches wide

      Correct answer

      Correct: R905.2.8.3 requires at least 4 inches by 4 inches.

    Explanation

    California Residential Code section R905.2.8.3 requires base flashing at a vertical sidewall, continuous or step, at least 4 inches high and 4 inches wide, with the vertical leg running under the siding.

Keep studying

Read the Section 3 study notes: Core Trades

All General Building topics

Study guides for this section

Test yourself

Try 25 free General Building practice questions from all five sections. Each answer explains the rule and names the code section it comes from. No sign-up.

See what the General Building exam covers