Skip to content
CalContractorPrep
Menu

CSLB General Building (B) practice questions: Personnel safety

Section 5 of 5: Safety

4 free practice questions on personnel safety, part of a section that is about 15% of the General Building exam. Try each one, then open the answer: every choice is explained, and the answer names the code section or public rule it comes from.

Questions and answers

  1. 1. A small remodeling job has 4 employees who stay on site all day. Under Cal/OSHA, what is the minimum toilet facility required?

    Safety

    • A. One single-user toilet facility designated for all-gender use
    • B. One toilet for each sex
    • C. None, if the crew works fewer than 8 hours a day
    • D. Two toilets, one of which may be a urinal
    Show answer

    Correct answer: A

    • A. One single-user toilet facility designated for all-gender use

      Correct answer

      Correct: with fewer than 5 employees, one single-user all-gender toilet is sufficient (section 1526(a), Exception 1).

    • B. One toilet for each sex

      Wrong: separate facilities for each sex are not needed when there are fewer than 5 employees.

    • C. None, if the crew works fewer than 8 hours a day

      Wrong: the rule has no exemption based on shift length.

    • D. Two toilets, one of which may be a urinal

      Wrong: two facilities are more than the small-crew exception requires.

    Explanation

    Title 8 section 1526(a) normally requires one toilet facility for each 20 employees or fraction of each sex, but Exception 1 says that where there are fewer than 5 employees, one single-user toilet facility designated for all-gender use is enough.

    Source

  2. 2. A crew will remove old painted trim in a remodel. The work is not abrasive blasting. Under Cal/OSHA, what is the permissible exposure limit for airborne lead, as an 8-hour time-weighted average?

    Safety

    • A. 2 micrograms per cubic meter
    • B. 10 micrograms per cubic meter
    • C. 30 micrograms per cubic meter
    • D. 50 micrograms per cubic meter
    Show answer

    Correct answer: B

    • A. 2 micrograms per cubic meter

      Wrong: 2 is the action level, not the exposure limit.

    • B. 10 micrograms per cubic meter

      Correct answer

      Correct: 10 micrograms per cubic meter (section 1532.1).

    • C. 30 micrograms per cubic meter

      Wrong: 30 micrograms per cubic meter was the action level before the 2025 amendment, not the exposure limit.

    • D. 50 micrograms per cubic meter

      Wrong: an outdated figure; the current limit is 10.

    Explanation

    Title 8 section 1532.1 (amended effective January 1, 2025) sets the permissible exposure limit for lead in construction at 10 micrograms per cubic meter of air as an 8-hour time-weighted average. The action level is 2 micrograms per cubic meter.

  3. 3. Under Cal/OSHA's construction rule on personal protective devices, how must personal protective equipment be selected?

    Safety

    • A. In one standard size so all equipment can be shared
    • B. By each worker, from any brand the worker prefers
    • C. So that it properly fits each affected employee
    • D. Only by a registered safety engineer
    Show answer

    Correct answer: C

    • A. In one standard size so all equipment can be shared

      Wrong: one size does not fit everyone; the rule requires proper fit for each employee.

    • B. By each worker, from any brand the worker prefers

      Wrong: the employer must make sure all PPE, even if the worker supplies it, meets Title 8 standards (section 1514).

    • C. So that it properly fits each affected employee

      Correct answer

      Correct: PPE must be selected to properly fit each affected employee (section 1514(f)).

    • D. Only by a registered safety engineer

      Wrong: section 1514 does not require a registered engineer to choose PPE.

    Explanation

    Title 8 section 1514(f), effective October 1, 2025, requires all personal protective equipment to be selected so that it properly fits each affected employee.

    Source

  4. 4. A crew is reroofing a single-story house with a 4:12 roof. The eave is 10 feet above the ground. Under Cal/OSHA, must the workers be protected from falling at the eave?

    Safety

    • A. No, residential roofs need protection only above 15 feet
    • B. No, because the slope is 7:12 or less
    • C. Yes, but only for workers using power tools
    • D. Yes, because the fall distance is 6 feet or more
    Show answer

    Correct answer: D

    • A. No, residential roofs need protection only above 15 feet

      Wrong: residential-type roofing has no 15-foot trigger; on slopes up to 7:12 the trigger is a fall distance of 6 feet or more.

    • B. No, because the slope is 7:12 or less

      Wrong: low slopes still need protection at 6 feet or more; steeper than 7:12 needs it at any height.

    • C. Yes, but only for workers using power tools

      Wrong: the rule applies to all workers exposed to the fall.

    • D. Yes, because the fall distance is 6 feet or more

      Correct answer

      Correct: 6 feet or more on slopes up to 7:12 (section 1731).

    Explanation

    Title 8 section 1731 (amended effective July 1, 2025) requires residential-type roofing workers on slopes from 0:12 up to and including 7:12 to be protected when the fall distance is 6 feet or more. A 10-foot eave exceeds that.

Keep studying

Read the Section 5 study notes: Safety

All General Building topics

Study guides for this section

Test yourself

Try 25 free General Building practice questions from all five sections. Each answer explains the rule and names the code section it comes from. No sign-up.

See what the General Building exam covers