Skip to content
CalContractorPrep
Menu

CSLB General Building (B) practice questions: Tile and stone

Section 4 of 5: Finish Trades

4 free practice questions on tile and stone, part of a section that is about 20% of the General Building exam. Try each one, then open the answer: every choice is explained, and the answer names the code section or public rule it comes from.

Questions and answers

  1. 1. The California Residential Code requires ceramic tile surfaces to be installed in accordance with which group of standards?

    Finish Trades

    • A. ANSI A108, A118, A136.1 and A137.1
    • B. ASTM E84 and UL 723
    • C. ASTM C1178 and C1278
    • D. ANSI/HPVA HP-1
    Show answer

    Correct answer: A

    • A. ANSI A108, A118, A136.1 and A137.1

      Correct answer

      Correct: R702.4.1 names the ANSI A108, A118, A136.1 and A137.1 standards.

    • B. ASTM E84 and UL 723

      These are flame spread tests for wall and ceiling finishes (R302.9.3).

    • C. ASTM C1178 and C1278

      These are standards for gypsum backer panels (Table R702.4.2), not tile installation.

    • D. ANSI/HPVA HP-1

      This is the standard for wood veneer paneling (R702.5).

    Explanation

    California Residential Code section R702.4.1 requires ceramic tile surfaces to be installed in accordance with ANSI A108.1, A108.4, A108.5, A108.6, A108.11, A118.1, A118.3, A136.1 and A137.1.

  2. 2. In an office building toilet room, the tile floor must meet the walls with a smooth, hard, nonabsorbent base that extends up the wall at least how far?

    Finish Trades

    • A. 2 inches
    • B. 4 inches
    • C. 6 inches
    • D. 8 inches
    Show answer

    Correct answer: B

    • A. 2 inches

      Too short; the base must extend at least 4 inches.

    • B. 4 inches

      Correct answer

      Correct: 1210.2.1 requires a base at least 4 inches high.

    • C. 6 inches

      More than the minimum required.

    • D. 8 inches

      More than the minimum required.

    Explanation

    California Building Code section 1210.2.1 requires toilet, bathing and shower room floors in other than dwelling units to have a smooth, hard, nonabsorbent surface, with a vertical base of the same kind extending at least 4 inches up the walls.

  3. 3. A custom tiled shower must have at least 1,024 square inches of finished floor area and must also be able to contain a circle of what diameter?

    Finish Trades

    • A. 24 inches
    • B. 28 inches
    • C. 30 inches
    • D. 36 inches
    Show answer

    Correct answer: C

    • A. 24 inches

      Smaller than the required 30-inch circle.

    • B. 28 inches

      Smaller than the required 30-inch circle.

    • C. 30 inches

      Correct answer

      Correct: 408.7 requires room for a 30-inch circle.

    • D. 36 inches

      Larger than the code minimum.

    Explanation

    California Plumbing Code section 408.7 requires a shower compartment to have a finished interior of at least 1,024 square inches and to be able to encompass a 30-inch circle, maintained to at least 70 inches above the drain outlet.

  4. 4. Wood-stud walls in a commercial building will be covered inside with tile and will be subject to water splash. What does the California Building Code require to protect the framing?

    Finish Trades

    • A. Pressure-treated studs
    • B. A 1-inch air space between the backer and the studs
    • C. Two coats of primer on the studs before the backer goes on
    • D. An approved moisture barrier
    Show answer

    Correct answer: D

    • A. Pressure-treated studs

      Wrong: the code calls for a moisture barrier, not treated lumber.

    • B. A 1-inch air space between the backer and the studs

      Wrong: an air space is not what 2511.5 requires.

    • C. Two coats of primer on the studs before the backer goes on

      Wrong: primer on studs is not an approved moisture barrier.

    • D. An approved moisture barrier

      Correct answer

      Correct: 2511.5 requires an approved moisture barrier over the framing.

    Explanation

    CBC section 2511.5 requires that where wood-frame walls or partitions are covered on the interior with cement plaster, tile or similar material and are subject to water splash, the framing be protected with an approved moisture barrier.

Keep studying

Read the Section 4 study notes: Finish Trades

All General Building topics

Test yourself

Try 25 free General Building practice questions from all five sections. Each answer explains the rule and names the code section it comes from. No sign-up.

See what the General Building exam covers