Skip to content
CalContractorPrep
Menu

CSLB General Building (B) practice questions: Floor covering

Section 4 of 5: Finish Trades

4 free practice questions on floor covering, part of a section that is about 20% of the General Building exam. Try each one, then open the answer: every choice is explained, and the answer names the code section or public rule it comes from.

Questions and answers

  1. 1. Particleboard is used as underlayment over the subfloor before resilient flooring goes down. What does the California Residential Code require?

    Finish Trades

    • A. Type PBU, at least 1/4 inch thick
    • B. Any grade, at least 1/8 inch thick
    • C. Type PBU, at least 3/4 inch thick
    • D. Exterior grade, at least 1/2 inch thick
    Show answer

    Correct answer: A

    • A. Type PBU, at least 1/4 inch thick

      Correct answer

      Correct: R503.3.2 requires Type PBU, 1/4 inch minimum.

    • B. Any grade, at least 1/8 inch thick

      The type is specified, and 1/8 inch is too thin.

    • C. Type PBU, at least 3/4 inch thick

      Type is right but 3/4 inch is not the minimum.

    • D. Exterior grade, at least 1/2 inch thick

      Not the type or thickness in R503.3.2.

    Explanation

    California Residential Code section R503.3.2 requires particleboard floor underlayment to be Type PBU and at least 1/4 inch thick.

  2. 2. A room is 15 ft by 18 ft. You add 10 percent waste for vinyl plank flooring sold in cartons of 22 square feet. How many cartons should you order?

    Finish Trades

    • A. 13 cartons
    • B. 14 cartons
    • C. 15 cartons
    • D. 16 cartons
    Show answer

    Correct answer: B

    • A. 13 cartons

      13 cartons cover only 286 sq ft, short of 297.

    • B. 14 cartons

      Correct answer

      Correct: 13.5 rounds up to 14 cartons.

    • C. 15 cartons

      More than needed.

    • D. 16 cartons

      More than needed.

    Explanation

    Area = 15 x 18 = 270 sq ft. With 10 percent waste: 270 x 1.10 = 297 sq ft. Cartons = 297 / 22 = 13.5, rounded up to 14.

    Common building practice; not a code requirement.

  3. 3. New flooring on an accessible route in an office leaves a 3/4-inch change in level where it meets the existing floor. What does the California Building Code require?

    Finish Trades

    • A. It may stay vertical if the edge has a contrasting color
    • B. A bevel with a slope no steeper than 1:2
    • C. A ramp that complies with the ramp or curb ramp sections
    • D. Nothing, because changes under 1 inch are exempt
    Show answer

    Correct answer: C

    • A. It may stay vertical if the edge has a contrasting color

      Wrong: only changes of 1/4 inch or less may be vertical, color or not.

    • B. A bevel with a slope no steeper than 1:2

      A 1:2 bevel is allowed only for changes between 1/4 and 1/2 inch.

    • C. A ramp that complies with the ramp or curb ramp sections

      Correct answer

      Correct: changes over 1/2 inch must be ramped per 11B-405 or 11B-406.

    • D. Nothing, because changes under 1 inch are exempt

      Wrong: there is no 1-inch exemption; anything over 1/2 inch must be ramped.

    Explanation

    CBC section 11B-303.4 requires changes in level greater than 1/2 inch to be ramped, complying with 11B-405 (ramps) or 11B-406 (curb ramps). Up to 1/4 inch may be vertical (11B-303.2), and 1/4 to 1/2 inch may be beveled no steeper than 1:2 (11B-303.3).

  4. 4. A flooring contractor is choosing a finish floor for an accessible route in a public building. The California Building Code requires the surface to be what?

    Finish Trades

    • A. Smooth, level and nonabsorbent
    • B. Carpeted with a pile no more than 1/2 inch
    • C. Sealed concrete or ceramic tile
    • D. Stable, firm and slip resistant
    Show answer

    Correct answer: D

    • A. Smooth, level and nonabsorbent

      Smooth and nonabsorbent is the toilet room floor requirement (1210.2.1), not the accessibility rule.

    • B. Carpeted with a pile no more than 1/2 inch

      Carpet is allowed but not required; 1/2 inch is the carpet pile limit when carpet is used.

    • C. Sealed concrete or ceramic tile

      No particular material is required; any surface that is stable, firm and slip resistant may be used.

    • D. Stable, firm and slip resistant

      Correct answer

      Correct: 11B-302.1 requires stable, firm and slip resistant surfaces.

    Explanation

    CBC section 11B-302.1 requires floor and ground surfaces on accessible routes and in accessible spaces to be stable, firm and slip resistant. Animal containment areas and areas of sport activity are excepted.

Keep studying

Read the Section 4 study notes: Finish Trades

All General Building topics

Test yourself

Try 25 free General Building practice questions from all five sections. Each answer explains the rule and names the code section it comes from. No sign-up.

See what the General Building exam covers